CrimpComponent folio · Load · Schenker
ZEN 50
12V watermaker with energy-recovery system. 50 L/h fresh-water production at ~240 W (~20 A @ 12 V).
Open in Crimp →
Schenker ZEN 50 Watermaker · 2 terminals
01 — Reference run
A sizing result with its assumptions attached.
Conductor10 AWG6 mm²
Fuse40 Apositive run
Voltage drop2.9%9.8 ft one way
Design current20 A12 V system
Sized against ABYC E-11 — the US reference, and what Transport Canada accepts as an alternative to TP 1332 for pleasure craft under 24 m. The Crimp engine applies its ordinary continuous-load headroom, voltage-drop budget, terminal clamp, and standard fuse ladder. The 9.8 ft one-way run is a stated reference, not a universal installation prescription.
02 — Catalog specification
The part the engine actually sees.
- Compatible systems
- 12 V
- Continuous draw
- 20 A
- Surge current
- 30 A
- Canvas footprint
- 220 × 110 px
Terminal map
| Terminal | Polarity | Direction | Rating |
|---|---|---|---|
| + | positive | input | 30 A |
| − | negative | input | 30 A |
03 — Supporting parts
What belongs around it.
- 19.7 ft total of 10 AWG (6 mm²) marine cable
- Four 10 AWG cable lugs matched to the equipment studs
- 40 A fuse and holder on the positive run
- Heat-shrink, strain relief, and terminal boots sized to the cable
See what it changes in your system
With JavaScript enabled, describe your existing boat, van, or off-grid system here. The model supplies topology; Crimp's engine computes the attachment, resized runs, checks, and supporting basket.