12.8V 230Ah Plus Low-Temp (200A BMS)
LiTime 12V 230Ah Plus LiFePO4 wiring diagram
12.8V 230Ah deep-cycle LiFePO4 battery with 200A continuous charge/discharge limits and low-temperature charge cutoff. Recommended charging is 46A at 14.4V ±0.2V. This Plus Low-Temp model has no Bluetooth or self-heating and is not an engine-starting battery.
- Nominal voltage
- 12.8 V
- Capacity
- 230 Ah
- Maximum discharge
- 200 A
Wiring diagram
How the Plus 230Ah is wired.
Open this example in Crimp to use your own parts and cable lengths. Review the assumptions and installation notes as you adapt the circuit.
Cable sizing for this example
Use the diagram as a starting point for your installation. Replace the example equipment and cable lengths with your own, and check the connections against your exact model's instructions.
Cable sizes depend on the connected equipment, current and cable lengths. Add those details in Crimp to size each run.
Installation notes
Before you install.
Open a question for model-specific guidance and sources.
Verified against the manufacturer's documentation (rev. 12.8V 230Ah Plus Low-Temp, 200A BMS; undated 8-page manual), checked 2026-10-19. Manufacturer documentation →
Which LiTime 230Ah battery is this?
This is the 12.8 V 230 Ah Plus Low-Temp model with a 200 A BMS. The manufacturer product page distinguishes it from the Bluetooth Smart and 24 V self-heating versions. Use it for house loads or energy storage; LiTime expressly excludes engine starting.
What charging and discharge limits apply?
Manual pages 2–3 specify 200 A continuous for both charge and discharge. The recommended charging current is 46 A, using CC/CV at 14.4 V ±0.2 V. The 600 A, five-second discharge capability is temporary and does not increase the continuous limit. Size external cable protection separately from the internal BMS.
How are the terminals connected?
The manual identifies positive and negative M8 × 1.25 posts with 12–14 Nm tightening torque. Fit the insulating caps after securing the lugs. This model has no Bluetooth or self-heating; the product page specifies that charging stops below 0°C and resumes at 5°C.
Technical reference
Specifications and terminal map.
Check the model, ratings and connection points against your own unit before choosing installation hardware.
Catalog specification
12.8V 230Ah deep-cycle LiFePO4 battery with 200A continuous charge/discharge limits and low-temperature charge cutoff. Recommended charging is 46A at 14.4V ±0.2V. This Plus Low-Temp model has no Bluetooth or self-heating and is not an engine-starting battery.
- Nominal voltage
- 12.8 V
- Capacity
- 230 Ah
- Maximum discharge
- 200 A
Terminal map
Catalog connection points, current direction and planning limits. Check the manufacturer's pinout and connector ratings before installation.
+
positive · bidi
−
negative · bidi
Sources and sizing method
Equipment specifications. Model details, ratings and terminal roles come from the catalog. Check your unit’s label and current manufacturer documentation for its exact revision.
Example sizing. Cable labels apply to the connected example, not a fixed cable size for this component. Set your actual equipment, current, lengths and installation conditions in Crimp before choosing hardware.
Read how the sizing worksNext step
Plan your installation with Plus 230Ah.
Open this example as a new project, or add this component to your existing diagram. Use your equipment and cable lengths to review the sizing.
Start drawing, sizing and checking without an account. Your drawing saves in this browser. See Pricing for the equipment allowance and the one-time export offer available to you.